Connect with your social network account

[OhioFitnessGarage]

Does anyone know how this bunching was done on the roller? And is there any special parts to do this?

[OhioFitnessGarage]

here is another photo

[BigRig]

@john,

I am going to answer it this way. I do not think that anything but a good 03 inches of the vinyl wrapped and extending past the foam bolster is required. A ring must have been sewn into the end and the bolster fitted that way. Big boys down there man especially with the lifting community better use some heavy guage viyl.

[Cody]

To slip the cover over I would think that it would have to be able to close on one end at least after it’s one. Idk if a zip tie sewn in or something similar. Maybe extra strong elastic?

[John]

Most likely there is a hem sewn on each end with a string inside or small rope, maybe a zip tie in side the hem. Once you install the sleeve is pulled over the round bun the string is pulled tight and tied off.

[BigRig]

Yes, has to be a tie and most likely tucked in there somewhere.